TM 9-2320-387-24-2
I
18-6. ENGINE WIRING HARNESS REPLACEMENT (Cont’d)
1
--
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Position harness (1) in approximate mounting 10cati01~
Connect body harness (12) to harness connector (11).
Connect harness connector (7) to protective control box receptacle (8).
Connect harness connector (6) to fan clutch time delay (9).
Install harness (1) on body (13) with clamp (2) and two capscrews (10).
Install harness (1) on body (13) with clamp (5), capscrew (4), and nut (3).
Apply antiseize compound to lead 3C (15), and install lead 3C (15) on body (13) with nut and
lockwasher assembly (14).
NOTE
Perform step 8 for Ml113 models. Perform steps 9 and 10 for
Ml114 models.
Inst,ah harness (1) on stud (17) at right cyhnder head (16) with clamp (20), lockwasher (18), and nut (19).
1nstaI.I
harness (1) on back side of bracket (21) at right cylinder head (16) with clamp (28), screw (26),
and locknut (27).
Install harness (1) on bracket (21) at right cylinder head (16) with clamp i22), washer’(23),
lockwasher (24), and capscrew (25).
18-40
