TM 9-2320-387-24-2
18-6. ENGINE WIRING HARNESS REPLACEMENT (Contd)
1
22.
Remove nut (211, lockwasher (20), clamp (221, and harness (19) from stud (18) on right front cylinder
head (17). Discard lockwasher (20).
23.
24.
Remove capscrew (271, lockwasher (261, washer (25), and clamp (24) from bracket (23) on right
cylinder head (17). Discard lockwasher (26).
Remove locknut (291, clamp (301, harness (191, and screw (28) from bracket (23) on right cylinder
head (17). Discard locknut (29).
25.
Remove nut and lo&washer assembly (43) and lead 3C (44) from body (42). Discard nut and
lockwasher assembly (43).
26.
Remove two capscrews (391, clamp (311, and harness (19) from body (42).
27.
Remove nut (32), capscrew (331, clamp (341, and harness (19) from body (42).
28.
Disconnect harness connector (35) from fan clutch. time delay (38).
29.
Disconnect harness connector (36) from protective control box receptacle (37).
30.
Disconnect body harness (41) from harness connector (40).
31.
Remove harness (19) from body (42).
NOTE
Perform step 22 for Ml113 models. Perform steps 23 and 24 for
Ml114 models.
18-39