TM 9-2320-387-24-2
I 18-4. STARTER REPAIR (Contd)
I
1
I
16.
17.
18.
19.
20.
21.
22.
Remove two nuts (12), lockwashers (ll), screws (8), washers (7), and two brush leads (10) from
starter motor frame (4). Remove two brushes (9) from brush holder (6). Discard two lock-
washers (11).
Remove two screws (l), two brush leads (2), and brushes (13) from field coil (3) and brush holder (6).
Remove four springs (5) from brush holder (6).
Remove four nut and lockwasher assemblies (14), rubber washers (15), and cover (16) from studs of
solenoid housing (18). Pull cover (16) away from solenoid housing (18) far enough to allow access to
series winding lead (19) and screw (20). Discard rubber washers (15) and nut and lockwasher
assemblies (14).
Remove screw (20), washer (21), and series winding lead (19) from cover (16), and remove cover (16)
and gasket (17) from solenoid housing (18). Discard gasket (17).
Remove snapring (31), spring retainer (30), spring (29), spring retainer (28), rubber boot (32), and
washer (33) from core shaft (27), and remove core shaft (27) from solenoid housing (18). Discard
snapring (3 1).
Hold core shaft (27) and remove locknut (26), washer (25), contact (24), spring (23), and washer (22)
from core shaft (27). Discard locknut (26).
18-16
