TM 9-2320-387-24-2
i
18-4. STARTER REPAIR (Cont’d)
I
9.
Scribe a locating mark (4) on pinion housing (1) and starter motor frame (3).
10. Remove seven capscrews (61, starter motor frame (3), gasket (51, and O-ring (2) from pinion
housing (1). Discard gasket (5) and O-ring (2).
11.
Remove two plugs (9) and pin (10) from shiR lever (8) and pinion housing (1).
NOTE
Armature and shift lever must be positioned as shown for removal
from pinion housing.
12.
Clamp pinion housing (1) in vise and remove three screws (17) from pinion housing (1). Slide
armature (7) and shift lever (8) out from pinion housing (1).
13.
Remove snapring (11) and pinion stop (12) from armature shaft (15), and slide clutch (13) off
armature shaft (15). Discard snapring (11) and pinion stop (12).
14.
Remove washer (14), pinion housing end plate (181, and washer (16) from armature shaft (15).
Discard washers (14) and (16).
15.
Remove gasket (19) from pinion housing end plate (18). Discard gasket (19).
18-14
