TM 9-2320-387-24-2
18-4. STARTER REPAIR (Cont’d)
8. Apply aircraft grease to armature shaft (321, shift lever studs (26), and the inside diameter of pinion
housing end plate seal (34).
9.
Install washer (331, pinion housing end plate (361, gasket (37), and washer (30) on armature
shaft (32).
10.
Install clutch (29) on armature shaft (32) with pinion stop (28) and snapring (27).
NOTE
Armature and shift lever must be positioned as shown for
installation into pinion housing.
11. Install pinion shift lever (25) and armature (31) on pinion housing (38). Install pinion housing end
plate (36) on pinion housing (38) with three screws (35). Tighten screws (35) to 40 lb-in. (5 N-m).
12.
Install pin (241 on pinion shift lever (25) and pinion housing (38) and install two plugs (23) on pinion
housing (38).
18-21
