TM 9-2320-387-24-2
18-4. STARTER REPAIR (Cont’d)
3. Position gasket (1) on cover (9) and connect series winding lead (5) to series winding connection (6)
with washer (4) and screw (3).
4.
Install cover (9) on solenoid housing (2) with four rubber washers (7) and nut and lockwasher
assemblies (8).
5.
Connect two brush leads (11) to field coil (12) and brush holder (15) with two screws (10).
6.
Connect two brush leads (19) to starter motor frame (13) with two washers (161, screws (171,
lockwashers (201, and nuts (21). Cover heads of screws (17) with adhesive sealant.
7.
Install two brushes (18) and two brushes (22) on brush holder (15) with four springs (14).
18-20
