TM 9-2320-387-24-2
1 18-4. STARTER REPAIR
I
I
I
This task covers:
a. Disassembly
b. Cleaning
c. Inspection
d. Assembly
e. Bench Testing and Adjustment
INITIAL SETUP:
Test Equipment
Switch (Appendix
B, Item 55)
Multimeter (Appendix B, Item 155)
Carbon pile (Appendix B, Item 52)
Armature test set (Appendix B, Item 53)
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Pinion stop and snapring kit
(Appendix G, Item 300)
Thrust washer and spacer kit
(Appendix G, Item 459)
Gasket set (Appendix G, Item 101)
Gasket set (Appendix G, Item 1031
Core parts kit (Appendix G, Item 26)
Gasket kit, commutator end head
(Appendix G, Item 1001
Materials/Parts
(Cont’d)
Two locknuts (Appendix G, Item 1641
Pinion O-ring (Appendix G, Item 2931
Washer kit (Appendix G, Item 468)
Adhesive sealant (Appendix C, Item 13)
Aircraft grease (Appendix C, Item 321
Lithium grease (Appendix C, Item 361
Lubricating oil (Appendix C, Item 49)
Core shaft nut tool (Appendix D, Fig. 631
Manual References
TM 9-2320-387-24P
Equipment Condition
Starter removed (para. 4-11).
Maintenance Level
Direct support
a. Disassembly
1.
Remove plug (4) and gasket (5) from pinion housing (3). Discard gasket (5).
2.
Using core shaft nut tool, remove locknut (2) from end of core shaft (1) located inside pinion
housing (3). Discard locknut (2).
18-12
