TM 9-2320-387-24-2
26-3. 9,000 LB WINCH REPAIR (Contd)
1
10.
InstalI gasket (5) and nylon bushing (4) on output ring gear (6).
NOTE
Ensure spline on drum support engages in output ring gear.
11.
12.
13.
14.
15.
16.
17.
18.
Install gear end drum support (2) on output ring gear (6).
Install gear housing (1) on gear end drum support (2) with ten hex-head screws (7). Tighten
hex-head screws (7) to 100 lb-in. (11.3 Nom).
Turn gear housing (1) over with gear end drum support (2) facing up.
Install driveshaft (3) in gear housing (1).
Apply grease to drum assembly (10) and brake (12).
With drum assembly (10) horizontal, install bearing (11) and brake (12) into drum assembly (10).
Install two nylon thrust washers (9) and oil seals (8) on drum assembly (10).
Install drum assembly (10) on gear end drum support (2). Rotate drum assembly (10) as needed to
engage driveshaft (3) and brake (12).
19.
20.
21.
22.
Install motor end drum support (19) on drum assembly (10).
Install drum bushing (181, brake driver (25), spacer (161, and bearing (15) in motor end drum
support (19).
Install gasket (17) on motor (13) and motor end drum support (191, ensuring to engage motor
shaft (26) into brake driver (25).
Install two hex-head screws (14) on motor (13) and motor end drum support (19). Tighten hex-head
screws (14) to 35 lb-in. (47 Nom).
26-8
I
