TM 9-2320-387-24-2
1
26-3.
9,000
LB WINCH
REPAIR (Cont’d)
I
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
Mark motor end drum support (6) and gear end drum support (7) for assembly.
Remove six capscrews (81, three tie rods (111, two springs (121, anchors (101, and plate (9) from motor
end drum support (6) and gear end drum support (7).
Place winch on end with motor end up and remove two hex-head screws (1) and motor (15) from
motor end drum support (6).
Remove gasket (4) and motor end drum support (6) from drum assembly (13). Discard gasket (4).
Remove bearing (2), spacer (141, brake driver (31, and drum bushing’@) from end drum support (6).
Remove drum assembly (13) from gear end drum support (7).
Remove two oil seals (16) and nylon thrust washers (17) from drum assembly (13).
Push brake (19) and bearing (18) through open end of drum assembly (13).
Remove driveshaft (22) from output ring gear (21).
Turn gear housing (23) over with gear end drum support (7) down and remove ten hex-head
screws (24) and gear housing (23) from output ring gear (21).
Remove gasket (20) from output ring gear (21). Discard gasket (20).
6
P
26-4
