TM 9-2320-387-24-2
26-3.
9,000
LB WINCH
REPAIR (Cont’d)
1 c. Inspection 1
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
NOTE
For general inspection instructions, refer to para. 2-15.
Inspect drum (5) for damage to splined end (9), two flanges (7), and tube (8). Replace if damaged.
Inspect gear end drum support (6) and motor end drum support (4). Replace if damaged.
Inspect gear housing (10). Replace if damaged.
Inspect gear teeth and machined surfaces of intermediate ring gear (2). Replace if damaged.
Inspect clutch lever (1) and driveshaft (3). Replace if damaged.
Inspect gear teeth, splines, and machined surfaces of output ring gear (141, output gear carrier (15),
intermediate gear carrier (131, input gear carrier (121, and input sun gear (11). Replace any
damaged parts.
Inspect brake assembly (24). Replace if damaged.
Inspect motor (231, spline (211, mating surface (201, and three terminals (22). Replace if damaged.
Inspect cover (16). Replace if damaged.
Inspect control pack (18) for damaged leads (171, breaks in plastic coating, and damaged mounting
base (19). Replace control pack (18) if damaged or repair plastic coating.
Inspect two thrust washers (251, seals (261, retaining rings (271, bearing (28), and detent spacer (29).
Replace if damaged.
26-6
