I
TM 9-2320-387-24-l
4-59. HEADLIGHT BEAM SELECTOR SWITCH AND BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General
mechanic’s
tool kit:
automotive
(Appendix
B, Item 1)
Riveter tool kit (Appendix B, Item 123)
Materials/Parts
Three lockwashers
(Appendix
G, Item 209)
Four rivets (Appendix
G, Item 330)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Battery
ground cables disconnected
(para. 4-68).
Maintenance
Level
Unit
[
NOTE
l Prior to removal, tag leads for installation.
l Pull back floor insulation for access to beam selector switch and
bracket.
1.
Remove three screws (71, lockwashers (61, switch (3), and shield (5) from bracket (4). Discard
lockwashers (6).
2.
Disconnect leads 16A (21, 17A U), and 18A (10) from switch (3).
3.
Remove four rivets (8) and bracket (4) from floor (9).
-1
1.
Install bracket (4) on floor (9) with four rivets (8).
2.
Connect leads 16A (2), 17A (11, and 18A (10) to switch (3).
3.
Install switch (3) and shield (5) on bracket (4) with three lockwashers (6) and screws (7).
FOLLOW-ON TASKS: l
.
w
\
Connect battery ground cables (para. 4-68).
Check headlight beam selection switch for proper operation (TM 9-2320-387-102
4-99
