TM
4-56. SIDE MARKER LIGHT ASSEMBLY REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Four locknuts (Appendix G, Item 111)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
l Battery ground cables disconnected (para. 4-68).
l Hood raised and secured (front side marker only)
(TM 9-2320-387-10).
Maintenance Level
Unit
NOTE
Replacement procedures for front and rear side marker light
assemblies are basically the same. This procedure covers the left
front side marker.
1
a. Removal
1
1.
Remove four screws (11, washers (21, and closeoff cover (3) from hood (4).
2.
Disconnect lead 489 (15) from hood wiring harness (14).
3.
Remove two screws (131, lens (111, and door (12) from side marker light (9).
4.
Remove four locknuts KI), washers (61, ground lead 92 (7), screws (lo), side marker light (91, and
gasket (81 from hood (4). Discard locknuts (5).
pi-Izzr1
1.
Install gasket (81, side marker light (9), and ground lead 92 (7) on hood (4) with four screws (101,
washers (61, and locknuts W, ensuring ground lead 92 (71 is under washer (6).
2.
Instail lens (11) and door (12) on side marker light.(g) with two screws (131.
3.
Connect lead 489 (15) to hood wiring harness (14).
4.
Install closeoff cover (3) on hood (41 with four washers (2) and screws (1).
4-94
