TM 9-2320-362-14&P
4-18. EES KIT INSTALLATION (Cont’d)
20.
21.
On rear side of enclosure panel (3), determine center of hole (1) by
measuring 4 inches (10.16 cm) up from bottom and 1 3/4 inches (4.45 cm)
over from left edge.
On side of battery box (6) next to enclosure panel (3), determine center
of hole (5) by measuring 6 inches (15.24 cm) down from top and
1 7/8 inches (4.76 cm) over from corner.
22.
23.
24.
25.
26.
When drilling, be sure to wear goggles for eye
Avoid skin contact with paint, primer, remover,
27.
l
l
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
Avoid skin contact with paint, primer, remover,
and thinner particularly if there are cuts
or open wounds on the hand.
Failure to do so
could result in serious injury.
Using 3/4-inch drill bit, drill pilot holes for holes (1) and (5).
Using 1 3/4-inch knockout punch and die, make hole (1) through enclosure
panel (3).
Using 1 3/4-inch knockout punch and die, make hole (5) through battery
box (6).
Install grommets (4) in holes (1) and (5).
On rear side of enclosure panel (3), determine center of hole (2) by
measuring 11 1/2 inches (29.21 cm) up from bottom and 11 1/2 inches
(29.21 cm) over from left edge.
WARNING
protection or injury to personnel may occur.
and thinner particularly if there are cuts
or open wounds on the hand.
Failure to do so
could result in serious injury.
Using 5/32-inch drill bit, drill hole (2) through rear side of
enclosure panel (3).
4-48
