TM 9-2320-362-14&P
4-18. EES KIT INSTALLATION (Cont’d)
12.
13.
14.
15.
16.
CAUTION
When cutting insulation, do not cut through en-
gine access cover or equipment’s effectiveness
may be degraded.
From underside of engine access cover (1),
insert insulation template (7)
into holes (4) and (5).
Secure template (7) to engine access cover (1) with two screws (8),
washers (3), and wing nuts (2).
Cut out insulation (6) around outline of insulation template (7).
Trim
cut edges of insulation as needed.
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
Remove two screws (8), washers (3), and wing nuts (2). Remove
insulation template (7).
Drilling from front side of engine access cover (l), enlarge hole (5)
using 1 5/8-inch hole saw.
4-45
