TM 9-2320-362-14&P
4.18 EES KIT INSTALLATION (Cent’d)
17. Remove passenger side fixed rear door (1) (TM 9-2320-280-20).
18. Determine center of four holes (2), (3), (4), and (5) on fixed rear
door (1) as follows:
(a) Measure 2 inches (5.08 cm) down from top edge and 8 l/2-inches
(21.59 cm) over from right edge for hole (2).
(b) Measure 12 inches (30.48 cm) down from top edge and 8 l/2-inches
(21.59 cm) over from right edge for hole (3).
(c)Measure 19 inches (48.26 cm) over from right edge and 12 inches
(30.48 cm) down from top edge for hole (4).
(d) Measure 2 inches (5.08 cm) down from top edge and 19 inches
(48.26 cm) over from right edge for hole (5).
WARNING
When drilling, be sure to wear goggles for eye
protection or injury to personnel may occur.
Avoid skin contact with paint, primer, remover,
and thinner particularly if there are cuts
or open wounds on the hand.
Failure to do so
could result in serious injury.
NOTE
Before drilling in fixed rear door, check loca-
tion of holes with holes in cover of power in-
terface box.
19. Using 5/16-inch drill bit, drill four holes (2), (3), (4), and (5) in
fixed rear door (l).
4-46
