TM 9-2320-280-20-3
11-46. WEAPON STATION HATCH HOLDDOWN STRIKER REPLACEMENT
This task covers:
a. Removal
b. Installation
lNITIAL SETUP:
Applicable Models
Materials/Parts
All models except M996, M996A1, M997,
Four locknuts (Appendix G, Item 58)
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038, M1038A1,
Manual References
M1042, M1097, M1097A1, M1097A2
TM 9-2320-280-24P
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
NOTE
This task covers the left hatch panel holddown striker. The right
hatch panel holddown striker is mounted directly on the panel.
1. Remove two locknuts (5), washers (4), screws (1), and holddown striker (2) from bracket (3). Discard
locknuts (5).
2. Remove two locknuts (7), washers (8), capscrews (9), washers (8), and bracket (3) from left hatch
panel (6). Discard locknuts (7).
b. Installation
1. Install striker (2) on bracket (3) with two screws (1), washers (4), and locknuts (5).
2. Install bracket (3) on left hatch panel (6) with two washers (8). capscrews (9), washers (8),
and locknuts (7). Tighten locknuts (7) to 6 lb-ft (8 N-m). ‘
11-67
