TM 9-2320-280-20-3
D-100
Change 1
Figure D-112. Punch Board Assembly.
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN/PART NUMBER
1
1
Plug Connector
5935-01-230-9304
2
1
Punch Board (fabricated in figure D-99)
64P44EP
3
1
Isolated Resistor Network
13F170
4-6
3
Diode
ECG125
7
1
Bussed Resistor Network
13F171
31
Wire (cut in figure D-99)
INSTRUCTIONS:
1. Install plug connector (1) on punch board (2).
2. Install fourteen wires to pins (8) marked 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, and 16 on plug
connector (1).
3. Install insulated resistor network (3) on punch board (2).
4. Install six wires to pins (8) marked 1, 4, 7, 8, 11, and 14 on isolated resistor network (3).
5. Install bussed resistor network (7) on punch board (2).
6. Install eleven wires to pins (8) marked 1, 2, 3, 4, 5, 8, 9, 10, 11, 12, and 14 on bussed resistor
network (7).
7. Install diodes (4), (5), and (6) on punch board (2).
