TM 9-2320-280-20-3
Change 1
D-105
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
Figure D-113. Test Module Assembly (Cont’d).
INSTRUCTIONS (CONT’D):
31. Place electrical insulation sleeving (3) over wire (10) marked 1 on plug connector.
32. Place twenty-four sections of insulation sleeving (3) over connected wires (6) and (11) on LEDs (5) and
heat-shrink into position.
33. Install four screws (4) in mount holes (12) on mini-box top section (1) and position four spacers (2) and
punch board (7) on screws (4) and secure with four washers (8) and nuts (9).
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN/PART NUMBER
2
4
Spacer
313-1437-024
3
25
Insulation Sleeving (install in figure D-110)
5970-00-812-2974
4
4
Screw
5305-00-928-9021
8
4
Washer
5310-00-880-5976
9
4
Nut
5310-00-934-9753
