TM 9-2320-280-20-3
Change 1
D-95
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
1.
Install four tiedown straps (11) in cable tie holders (10) and secure wires (2) to cable tie holders (10)
with tiedown straps (11).
2.
Install two loop clamps (4) on wires (2) of body harness connector and receptacle with screws (3),
washers (8), and nuts (9).
3.
Install two loop clamps (12) on wires (2) of engine harness connector and receptacle with screws (3),
washers (8), and nuts (9).
4.
Cut two 48-in. (1,219.2 mm) sections of conduit insulation (5).
5.
Remove ten tiedown straps (7) from wires (2) of body harness connector and receptacle.
6.
Position two sections of conduit insulation (5) over wires (2) of body harness connector and receptacle
and secure with tape (6).
7.
Cut two 54-in. (1,371.6 mm) sections of conduit insulation (13).
8.
Remove twelve tiedown straps (7) from wires on engine harness connector and receptacle.
9.
Position sections of conduit insulation (13) over wires (2) on engine harness connector and receptacle
and secure with tape (6).
Figure D-108. Terminal Strip Installation.
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN/PART NUMBER
3
4
Screw
5305-00-984-6210
4
2
Loop Clamp
5340-00-057-2904
5
2
Conduit Insulation: 48 in.
68240
6
AR
Tape
7510-00-802-8311
8
4
Washer
5310-00-883-9384
9
4
Nut
5310-00-934-9758
11
4
Tiedown Strap
5975-00-074-2072
12
2
Loop Clamp
5434-00-724-7038
13
2
Conduit Insulation: 54 in.
68243
