TM 9-2320-280-20-3
Change 1
D-91
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
Figure D-105. Receptacle Plug and Pin Assemblies (Contd).
INSTRUCTIONS:
1. Cut fourteen sections of electrical wire (2) to length as shown.
2. Install fourteen receptacle pins (1) on wires (2) as shown.
3. Using fourteen wire markers, mark wires (2) with numbers 1 through 13 and 16 as shown.
4. Install eleven terminal lugs (4) on wires (2) marked 2, 3, 4, 5, 6, 7, 9, 10, 12, 13, and 16 as shown.
5. Install two receptacle pins (1) (without wires) in slotted positions marked 14 and 15 on receptacle
plug (5).
6. Install fourteen receptacle pins (1) (with wires connected) in slotted positions marked 1, 2, 3, 4, 5, 6, 7,
8, 9, 10, 11, 12, 13, and 16 on receptacle plug (5).