TM 9-2320-280-20-3
D-92
Change 1
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
NOTE
• Ensure wire markers match letter identification for connector
and receptacle harness assemblies.
• Trim excess wire to required length when installing wire and
terminal lugs to terminal block assembly.
1.
Route wires (5) from body harness receptacle (6) through grommet (7).
2.
Install eight terminal lugs (3) on wires (5) from body harness receptacle (6).
3.
Install wires (5) marked A, B, C, D, E, F, G, and H on body harness receptacle (6) to matching letters
on terminal block assembly (4).
4.
Route wires (10) from body harness connector (8) through grommet (9).
5.
Install eight terminal lugs (3) on wires (10) from body harness connector (8).
6.
Install wires (10) marked A, B, C, D, E, F, G, and H on body harness connector (8) to matching
letters on terminal block assembly (4).
7.
Route wires (13) on engine harness connector (14) through grommet (15).
8.
Connect three wires (12) marked D, E, and F on engine harness connector (14) to matching letters
on terminal block assembly (11). Do not tighten screws.
9.
Install six terminal lugs (3) on wires (13) from engine harness connector (14)
10.
Install wires (13) marked A, B, C, G, H, and I on engine harness connector (14) to matching letters
on terminal block assembly (11).
11.
Route wires (2) on engine harness receptacle (1) through grommet (16).
12.
Connect three wires (12) marked D, E, and F on engine harness receptacle (1) to matching letters on
terminal block assembly (11).
13.
Install six terminal lugs (3) on wires (2) from engine harness receptacle (1).
14.
Install wires (2) marked A, B, C, G, H, and I on engine harness receptacle (1) to matching letters on
terminal block assembly (11).
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN
3
28
Terminal Lug
5940-00-283-5280
