TM 9-2320-280-20-3
Change 1
D-89
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
Figure D-104. Terminal Block Assemblies and Cable Tie Holder Installation.
INSTRUCTIONS:
1. Using wire marker (7) and 6-in. and 7-in. terminal block assemblies, locate and mark sections as
shown.
2. Install 6-in.and 7-in. terminal block assemblies in mini-box bottom section (5) with four screws (4),
washers (9), and nuts (8).
3. Install four cable tie holders (2) in mini-box bottom section (5) with eight screws (3), washers (10), and
nuts (11).
4. Install two non-metallic grommets (1) in holes A on mini-box bottom section (5).
5. Install two non-metallic grommets (6) in holes B on mini-box bottom section (5).
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN/PART NUMBER
1
2
Grommet, Non-metallic
5325-00-270-8890
2
4
Cable Tie Holder
MB4A
3
8
Screw
5305-00-958-4353
4
4
Screw
5305-00-984-6210
5
1
Mini-box (bottom section)
5999-00-971-8848
6
2
Grommet, Non-metallic
5325-00-309-7164
7
1
Wire Marker
46F5981
8
4
Nut
5310-00-934-9758
9
4
Washer
5310-00-883-9384
10
8
Washer
5310-00-880-5976
11
8
Nut
5310-00-934-9753
