TM 9-2320-280-20-3
D-78
Change 1
Figure D-96. Body Harness Receptacle Fabrication.
MATERIAL BLOCK
STOCK SIZE
DESCRIPTION
SPECIFICATION
14 AWG
WIRE, ELECTRICAL
MIL-C-13486
N/A
INSULATION SLEEVING
MIL-I-23053/2
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
NOTE
When connecting electrical wire to connector pins on engine
harness plug connector, use NSN 3439-00-133-1108 solder. (Refer
to TB SIG-222 for soldering.)
1.
Cut eight sections of wire (2) to length as shown.
2.
Cut eight sections of insulation sleeving (1) as shown.
3.
Position eight sections of insulation sleeving (1) on wires (2).
4.
Connect eight sections of wire (2) to receptacle pins marked A, B, C, D, E, F, G, and H on recep-
tacle (5). Place insulation sleeving (1) over wires (2) and receptacle pins and into position as shown.
5.
Apply sealant NSN 8040-00-225-4918 to receptacle pins, wires, and sleeving.
6.
Use wire markers (3) on eight sections of wire (2) to locate and mark wires. Secure eight sections of
wire (2) with five tiedown straps (4).
ITEM
MATERIALS
NO.
REQ’D
DESCRIPTION
NSN/PART NUMBER
1
8
Insulation Sleeving: 2 in.
5970-01-815-1295
2
8
Electrical Wire: 48 in.
6145-00-152-6499
3
8
Wire Marker
46F5981
4
5
Tiedown Strap
5975-00-074-2072
5
1
Receptacle
5935-00-738-8328
