TM 9-2320-280-20-3
Change 1
D-83
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
NOTE
When connecting electrical wire to connector pins on engine
harness receptacle, use NSN 3439-00-133-1108 solder. (Refer to
TB SIG-222 for soldering.)
1.
Cut three sections of electrical wire (2) to length as shown.
2.
Cut three sections insulation sleeving (1) to length as shown.
3.
Position three sections of insulation sleeving (1) on wires (2).
4.
Connect three wires (2) to receptacle pins marked D, E, and F on receptacle connector (7). Place
insulation sleeving (1) over wires (2) and receptacle pins and heat-shrink insulation sleeving (1) into
position.
5.
Apply sealant NSN 8040-00-225-4918 to three wires (2) and insulation sleeving (1) on receptacle
connector (7).
6.
Cut six sections of electrical wire (5) to length as shown.
7.
Cut six sections of insulation sleeving (6) to length as shown.
8.
Position six sections of insulation sleeving (6) on wires (5).
9.
Connect six wires (5) to receptacle pins marked A, B, C, G, H, and I on receptacle connector (7).
Place electrical insulating sleeving (6) over wires (5) and receptacle pins and heat-shrink insulation
sleeving (6) into position.
10.
Use wire markers (3) on nine sections of wire to locate and mark wires. Secure wires with six
tiedown straps (4).
