TM 9-2320-280-20-3
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont’d)
INSTRUCTIONS:
1.
2.
3.
4.
5
Figure D-93. Parking Brake Lever.
CAUTION
When drilling through the transmission cowl, be careful not to drill
into the transmission housing.
NOTE
The location of the mounting hole will vary depending on vehicle
configuration. Locate the hole in a suitable place, near the driver’s
seat
Drill a 1/4-in. hole in the transmission cowl (7), near the driver’s seat (10).
Cut chain (4) to desired length and install the clamp (1) on chain (4) with capscrew (5), lockwasher (2),
and nut (3).
Install chain (4) on transmission cowl (7) with capscrew (6), lockwasher (9), and nut (8).
With the parking brake applied, slip clamp (1) over lever (11) to lock it in place. When not in use, stow
the chain lock out of the way.
Paint chain lock red for easy identification.
D-73
