TM 9-2320-280-20-3
Change 1
D-81
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
INSTRUCTIONS:
NOTE
When connecting electrical wire to connector pins on engine
harness plug connector, use NSN 3439-00-133-1108 solder. (Refer
to TB SIG-222 for soldering.)
1.
Cut three sections of electrical wire (6) to length as shown.
2.
Remove 3-in. (76.2 mm) section of electrical insulation from electrical wire (6).
3.
Cut three sections of insulation sleeving (7) to length as shown.
4.
Position three sections of insulation sleeving (7) over wires (6).
5.
Using plug connector (1), disassemble shell, coupling nut (5), ferrule, and grommet.
6.
Place coupling nut (5) and ferrule over three wires (6).
7.
Place three wires (6) in holes marked D, E, and F in grommet.
8.
Connect three wires (6) to receptacle pins marked D, E, and F on shell.
9.
Cut six sections of electrical wire (2) to length as shown.
10.
Place six wires (2) in coupling nut (5), ferrule, and holes marked A, B, C, G, H, and I on grommet.
11.
Connect six wires (2) to receptacle pins marked A, B, C, G, H, and I on shell.
12.
Position grommet and ferrule in shell and secure with coupling nut (5). Using three wires (6) with
insulation, heat-shrink sleeving (7) in position.
13.
Apply sealant NSN 8040-00-225-4918 to three wires (6) and insulation sleeving (7) on plug
connector (1).
14.
Using plug connector (1) and wire markers (3), locate and mark nine wires. Secure nine wires with
six tiedown straps (4).
