TM 9-2330-392-14&P
Change 2
4-67
4-27
HYDRAULIC BRAKE ACTUATOR ASSEMBLY MAINTENANCE (CONT).
4.
Install master cylinder (5) with attached mounting plate (27) into actuator housing (14). Install four new cap-
screws (29) to secure master cylinder mounting plate (27) to brake actuator housing (14).
5.
Install damper (19) on lunette (11) with damper pin (16) and new cotter pin (17).
6.
Position two rollers (18), with beveled sides facing out, on either side of damper (19) inside lunette (11). Use5/8”
deep well socket to hold damper (19) and two rollers (18) in place.
NOTE
5/8” deep well socket will be pushed out as master pin is installed.
7.
Install lunette (11) on brake actuator (14) with master pin (12), washer (15), and new cotter pin (13). Torque mas-
ter pin (12) to 50 ft. lbs. (68 N•m), then back off 1/4 turn.
