TM 9-2330-392-14&P
4-68/(4-69/4-70 Deleted)
Change 2
4-27
HYDRAULIC BRAKE ACTUATOR ASSEMBLY MAINTENANCE (CONT).
e.
INSTALLATION
1.
Position actuator assembly (8) on trailer.
NOTE
5/8” capscrew (10) is installed in rear bolt hole and 1/2” capscrew (10) is installed in front bolt hole.
2.
Install two capscrews (10), two washers (7), and two locknuts (6) securing hydraulic actuator assembly to trailer.
Torque capscrews to 105 ft-lb (142 N•m).
NOTE
Master cylinder orifice (4) requires a 12-mm wrench.
3.
Remove temporary plug from flex brake line fitting end (3).
4.
Install flex brake line (2) in master cylinder orifice (4). Tighten flare fitting (3).
5.
Remove cap (1) from master cylinder (5).
6.
Install cover (9) on master cylinder (5). Then reinstall cap (1) on master cylinder (5).
FOLLOW-ON TASKS:
•
Bleed hydraulic system (para 4-26).
•
Install safety chains (para 4-35).
Paragraph 4-28 is now included in Paragraph 4-27.
Pages 4-69 and 4-70 have been deleted per Change 2.
Paragraph 4-28A, pages 4-70.1 through 4-70.8, is deleted per Change 2.
