TM 9-2320-387-24-2
18-5. STE/ICE-R WIRING HARNESS REPLACEMENT (Cont’d)
I
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
Pull harness (20) through protective coil (19).
Insert harness (20) through battery compartment (4) and install grommet (3) on battery
compartment (4).
Install harness leads 6B-6C (24) and 6A (23) on power stud (22) with lockwasher (26) and nut (25).
Slide boot (211 over power stud (22).
.
Install harness lead 8A (2) on right side of shunt (1) with lockwasher 161 and screw (5).
Install harness leads 599C (9),57T-9A (81, and 7B-7D (71 on left side of shunt (1) with lock-
washer (6) and screw (5).
Install leads 74A (33) and 74B (321 on starter solenoid (10) with clip (31) and screw (30).
Install harness lead 3D (16)
on starter terminal (29) with lockwasher (28) and nut (27).
Install harness leads 6A (23),81B (121, and 81A (131 on starter (111 with lockwasher (14) and nut (15).
Install leads 3D (16), 6A (231, 74B (321, and 81A (13) on starter (11) with clamp (17) and screw (18).
Tighten nut (271 to 15-20 lb-ft (20-27 N-m). Using torque adapter, tighten nut (15) to 25-30 lb-ft
(34-41 N-ml.
18-32
