TM 9-2320-387-24-2
18-5. STE/ICE-R WIRING HARNESS REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
Manual Reference
General mechanic‘s tool kit:
TM 9-2320-387-24P
automotive (Appendix B, Item 1)
Equipment Condition
Special Tools
l Battery holddown removed (para. 473).
Torque adapter, S/Pin. (Appendix B, Item 134)
l Engine access cover removed (para. 10-22).
Materials/Parts
Maintenance Level
Five lo&washers (Appendix G, Item 2381
Direct support
Four nut and lockwasher assemblies
(Appendix G, Item 251)
Antiseize compound (Appendix C, Item 16)
1 a. Removal 1
1.
2.
3.
4.
5.
6.
7.
8.
18-28
Prior to removal, tag leads for installation.
Remove two screws (5), lockwashers (61, and STEWE-R harness leads 7B-7D (7),8A (2),
57T-9A (8), and 599C (9) from shunt (1). Discard lockwashers (61.
Slide boot (21) off power stud (22) and remove nut (251, lockwasher (261, and leads 6B-6C (24) and
6A (23) from power stud (22). Discard lockwasher (26).
Remove nut (271, lockwasher (281, and lead 3D (16) from starter terminal (29). Discard lock-
washer (28).
Remove nut (151, lockwasher (141, leads 8l.A (13),81B (121, and 6A (23) from starter (11). Discard
lockwasher (14).
Remove screw (301, clip (311, and leads 74B (32) and 74A (33) from starter solenoid (10).
Remove screw (181, clamp (171, and leads 3D (16), 6A (23L74B (321, and 8l.A (13) from starter (11).
CAUTION
Use care when removing harness. Snagging or pulling may cause
damage to harness.
Remove harness (20) and grommet (3) from battery compartment (4).
