b. Installation
1.
Install harness (9) on body (1) in approximate mounting location.
CAUTION
Use care when routing harness. Snagging or pulling may cause
damage to harness.
2.
Connect harness connector (8) to fuel pressure transducer connector (7).
3.
Connect harness connector (18) to rpm sensor connector (19) at right front wheelwell (17).
4.
Install harness (9) and body harness (11) on body (1) with two clamps (12) and screws (10).
Finger-tighten screws (10).
5.
Install DCA cable (6) on body (1) with three screws (4), washers (14), and nut and lockwasher
assemblies (13).
6.
Apply antiseize compound to harness ground 7C (15) and install cover retainer (3) and harness
ground 7C (15) on body (1) and DCA cable (6) with screw (4), washer (14), and nut and lockwasher
assembly (13).
7.
Install cover (5) on DCA cable (6).
8.
Install harness (9) on body (1) with three clamps (16) and screws (2). Finger-tighten screws (2).
9.
Tighten screws (2) and (10).
18-5. STE/ICE-R WIRING HARNESS REPLACEMENT (Cont'd)
9.
Remove three screws (2) and clamps (16) from harness (9) and body (1).
10.
Remove two screws (10) and clamps (12) from body harness (11), harness (9), and body (1).
11.
Disconnect harness connector (18) from rpm sensor connector (19) at right front wheelwell (17).
12.
Disconnect harness connector (8) from fuel pressure transducer connector (7).
13.
Remove cover (5) from STE/ICE-R Diagnostic Connector Assembly (DCA) cable (6).
14.
Remove nut and lockwasher assembly (13), washer (14), harness ground 7C (15), screw (4), and
cover retainer (3) from body (1) and DCA cable (6). Discard nut and lockwasher assembly (13).
15.
Remove remaining three nut and lockwasher assemblies (13), washers (14), and screws (4) from
DCA cable (6) and body (1). Discard nut and lockwasher assemblies (13).
16.
Remove DCA cable (6) and harness (9) from body (1).
NOTE
Refer to para. 4-80 for wiring harness connector repair instructions.
17.
Repair or replace harness (9).
TM 9-2320-387-24-2
18-30
Change 1
