TM 9-2320-387-24-2
I
1 l-78.
SHELTER REPLACEMENT
I
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Ml113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eight capscrews (Appendix G, Item 18)
Eight lockwashers (Appendix G, Item 225)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Tailgate lowered (TM 9-2320-387-10).
General Safety Instructions
Direct all personnel to stand clear during hoisting
operations.
Maintenance Level
Unit
plYiizq
WARNING
Direct all personnel to stand clear during hoisting operations. A heavy,
swinging load can cause injury to personnel and damage to equipment.
1. Position chain hoist (2) over top of shelter (3).
2.
Connect lifting chains (1) to chain hoist (2) and four comers of shelter (3).
NOTE
l It may be necessary to detach cab rear panel straps and turnbuttons and
roll cab rear panel upward to gain access to front mounting brackets.
l Note number and location of shims prior to removal for installation.
3.
Remove eight capscrews (12), lo&washers (111, washers (101, and four reinforcements (91 from
mounting brackets (6) and support assembly (41, and remove shims (7), if present. Discard cap-
screws (12) and lockwashers (11).
4.
Using chain hoist (2), remove shelter (3) from support assembly (4).
5.
Remove mounting brackets (6) (para. 11-76).
Ib.lnstallationl
WARNING
Direct all personnel to stand clear during hoisting operations. A heavy,
swinging load can cause injury to personnel and damage to equipment.
1. Install mounting brackets (para. 11-73).
2.
Position shelter (3) over support assembly (4) and gradually lower shelter (3) into position on
support assembly (4) with front mounting points (5) aligned.
NOTE
Shelter should be tightly fitted on front of support assembly and centered fi-om
side to side. Shims should only be added at rear shelter mounting brackets.
3.
Install shelter (3) on front of support assembly (4) and two mounting brackets (6) with reinforcements (91,
four washers (lo), lockwashers (111, and capscrews (12). Tighten capscrews (12) to 90 lb-R (122 N-m) and
capscrews (8) to 60 lb-R (81 N-m).
1 l-140
