TM 9-2320-387-24-2
I-- 1 l-79. SHELTER SUPPORT ASSEMBLY REPLACEMENT
I
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Ml113
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Locknut (Appendix G, Item 109)
Sixteen locknuts (Appendix G, Item 134)
Four locknuts (Appendix G, Item 184)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
l Shelter carrier tailgate brackets removed
(para. 11-74).
l Fuel filler housing removed (para. 10-2).
l Rear soft top curtain rolled up (TM 9-2320-387-10).
l Shelter removed (para. 11-78).
Maintenance Level
Unit
I a. Removal 1
1.
2.
3.
4.
5.
6.
7.
8.
Remove two locknuts (24), washers (2), capscrews (4), washers (5), and spacers (6)
from support
assembly (27), cargo floor (22), and B-beam (26). Discard locknuts (24).
Remove six locknuts (24), washers (2), reinforcement plates (23) and (25), six capscrews (3),
washers (2), and spacers (1) from support assemb!y (27), cargo floor (22),
and B-beam (26). Discard
locknuts (24).
Remove two locknuts (21), washers (7), capscrews (9), and washers (10) from support
assembly
WY
and cargo floor (22). Discard locknuts (21).
Remove locknut (34), washer (33), capscrew (29), and washer (30)
from clamp (3‘2)
on fuel
filler
spout (28) and body (31). Pull fuel filler spout (28) away for access to locknut (21). Discard locknut (34).
Remove two locknuts (21), washers (7), capscrews (8), and washers (7) from support assembly (27)
and cargo floor (22). Discard locknuts (21).
Remove four locknuts (19), washers (14), capscrews (13), and washers (14) from support assembly (27
and cargo floor (22). Discard locknuts (19).
Remove three locknuts (20), washers (15), capscrews (16), and washers (15) from support
assembly (27), cargo floor (22), and D-beam (17). Discard locknuts (20).
Remove locknut (18), washer (12), capscrew (ll), washer (12), and support assembly (27)
from cargo
floor (22) and D-beam (17). Discard locknut (18).
b. Installation
NOTE
Do not tighten hardware until all hardware is installed.
1.
Install support assembly (27) on cargo floor (22) and D-beam (17) with washer (12), capscrew (ll),
washer (12), and locknut (18).
2.
Install three washers (l5), capscrews (16), washers (15), and locknuts (20) on support assembly (27),
cargo floor (22), and D-beam (17).
3.
Install four washers (14), capscrews (13), washers (14), and locknuts (19) on support assembly (27)
and cargo floor (22).
11-142
