33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d)
TM 9-2320-387-24-2
33-92
Change 1
1.
Cut two metal strips (1) from sheet metal, and mark two reference lines (2), centerline (3), and
directional arrow (4), and identify as metal strips C and D.
2. Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip C (1).
3.
Bend metal strip C (1) 1.50-in. (38.10-mm).
4. Locate, mark, and drill twenty 0.187-in. (4.75-mm) diameter holes through metal strip D (1).
5.
Bend metal strip D (1) 1.50-in. (38.10-mm).
c. Metal Strips Fabrication
METRIC CONVERSION
2.50 IN.
63.50 MM
3.50 IN.
76.20 MM
8.50 IN.
215.90 MM
29.70 IN.
754.38 MM
METRIC CONVERSION
0.60 IN.
15.24 MM
0.75 IN.
19.05 MM
1.25 IN.
31.75 MM
1.40 IN.
35.56 MM
1.50 IN.
38.10 MM
DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES
DRILL TWENTY 0.187-IN. (4.75-MM) DIAMETER HOLES
29.70
