33-14. RIGHT REAR FLOOR PANEL REPAIR (Cont’d)
TM 9-2320-387-24-2
33-90
Change 1
1.
Cut reinforcement strip (1) from sheet metal, and mark four reference lines (2), centerline (3), and
identify as A on reinforcement strip (1).
2.
Locate, mark, and drill twenty-one 0.187-in. (4.75-mm) diameter holes and a 0.750-in.
(19.050-mm) diameter hole through reinforcement strip A (1).
3.
Remove all burrs and round sharp edges of reinforcement strip A (1).
4.
Cut reinforcement strip (4) from sheet metal, and mark four reference lines (5) and centerline (6).
Identify reinforcement strip (1) as B.
5.
Locate, mark, and drill eighteen 0.187-in. (4.75-mm) diameter holes and a 0.500-in. (12.700-mm)
diameter hole through reinforcement strip B (4).
6.
Remove all burrs and round sharp edges of reinforcement strip B (4).
b. Reinforcement Strips Fabrication
4.00
0.75
0.75
0.75
0.75
DRILL 0.750-IN. (19.050-MM)
DIAMETER HOLE
DRILL TWENTY-ONE 0.187-IN. (4.75-MM) DIAMETER HOLES
2.00
