TM 9-2320-387-24-l
5-2. TRANSMISSION SERVICE (Cont’d)
b. Trammission Filter Removal
CAUTION
Transfer case must be supported during removal and installation of
crossmember for access to oil pan capscrew and to prevent damage to
equipment.
1. Place support under transfer case and remove two locknuts (31, washers (21, capscrews (61, and
crossmember (4) from support brackets (1) and (5). Discard locknuts (3).
NOTE
Oil pan gasket is reusable. Discard only if damaged.
2.
Remove seventeen capscrews (121, oil pan (111, and gasket (10) from transmission (7).
3.
Remove magnet (9) from oil pan (11). Remove filter (8) from transmission (7).
WARNING
Drycleaning solvent is flammable and will not be used near an open
flame. A 6re extinguisher will be kept nearby when the solvent is used.
Use only in well-ventilated places. Failure to do this may result in
injury to personnel and/or damage to equipment.
4.
Clean oil pan (11) thoroughly with drycleaning solvent.
c Transmission
Filter Installation
1.
Install filter (8) in transmission (7). Install magnet (9) in oil pan (11).
2.
Install gasket (10) and oil pan (11) on transmission (7) with seventeen capscrews (12).
3.
Install crossmember (4) on support brackets (1) and (5) with two capscrews (61, washers (21, and
locknuts (3). Tighten locknuts (3) to 90 lb-R (122 N-m).
4.
Remove support from transfer case.
d. Replenishing Fluid
1.
Remove transmission oil dipstick (14) from dipstick tube (13).
2.
Check transmission fluid and fill to proper level (TM 9-2320-387-10).
3.
Install transmission oil dipstick (14) in dipstick tube (13).
5-4
