TM 9-2320-387-24-l
I
5-2. TRANSMISSION SERVICE
This task covers:
a. Draining Fluid
b. Transmission Filter Removal
c. Transmission
Filter Installation
d. Replenishing
Fluid
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive
(Appendix B, Item 1)
Maintenance
and repair shop equipment:
automotive
(Appendix B, Item 2)
RIateriaWParts
Filter assembly (Appendix G, Item 51)
Transmission
oil pan gasket
(Appendix G, Item 64)
TWO locknuts (Appendix G, Item 157)
Transmission
fluid (Appendix C, Item 37)
Drycleaning
solvent (Appendix C, Item 26)
nlanual References
TM 9-2320-387-10
TM 9-2320-387-24P
General Safety Instructions
Drycleaning
solvent is flammable
and will not be
used near an open flame.
nlaintenonce Level
Unit
.
a. Draining Fluid
NOTE
l Do not shift through driving gear ranges when warming trans-
mission fluid for removal. Shifting through driving gear ranges
is a procedure
used only when refilling
transmission
fluid.
l Transmission
should be warm when draining fluid.
l Have drainage container ready to catch fluid.
1.
Remove drainplug
(1) and gasket (2) from oil pan (3). Allow fluid to drain.
NOTE
Inspect fluid for grit, foaminess, and/or milkiness. If present, refer to
DS maintenance
(chapter 14).
2.
Install gasket (2) and drainplug
(1) in oil pan (3) and tighten drainplug (1) to 20 lb-ft (27 N-m).
5-2
