11-92. RIFLE MOUNTING CLAMP BRACKET REPLACEMENT
This task covers:
a. Removal
b. Installation
a. Removal
1.
Remove two locknuts (5), washers (3), capscrews (4), washers (3), and clamp bracket (2) from
A beam (1). Discard locknuts (5).
NOTE
Perform step 2 for M1025A2 vehicles only.
2.
Remove two locknuts (6), washers (7), capscrews (9), washers (7), and clamp bracket (8) from
B pillar (10). Discard locknuts (6).
NOTE
Replacement procedures for the front and rear (rear bracket installed on
M1025, M1025A1, M1025A2, M1026, M1026A1, M1043, M1043A1, M1043A2,
M1044, and M1044A1 vehicles only) rifle mounting clamp brackets are
basically the same. This procedure covers the right front and right rear
bracket (M1025A2 only).
INITIAL SETUP:
Applicable Models
All models except M996, M996A1, M997,
M997A1, M997A2, M998, M998A1, M1035,
M1035A1, M1035A2, M1037, M1038, M1038A1,
M1042, M1097, M1097A1,M1097A2, M1123
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two locknuts (Appendix G, Item 58)
Two locknuts (Appendix G, Item 98)
Manual References
TM 9-2320-280-24P
Equipment Condition
Rifle mounting clamp removed (para. 11-91).
b. Installation
1.
Install clamp bracket (2) on A beam (1) with two washers (3), capscrews (4), washers (3), and
locknuts (5).
NOTE
Perform step 2 for M1025A2 vehicles only.
2.
Install clamp bracket (8) on B pillar (10) with two washers (7), capscrews (9), washers (7), and
locknuts (6).
TM 9-2320-280-20-3
11-134
Change 1