TM 9-2320-280-20-3
10-109. WINCH CONTROL BOX REPLACEMENT
I
This task covers:
a. Removal
b. Installation
lNITIAL SETUP:
Applicable Models
Materials/Parts
M1026, M1026A1, M1036, M1038, M1038A1,
Lockwasher (Appendix G, Item 124)
M1042, M1044, M1044A1, M1046, M1046A1
Manual References
Tools
TM 9-2320-280-24P
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Equipment Condition
Battery ground cable disconnected (para. 4-73).
a. Removal
1. Open winch control box (12) and pull control cable (8) out.
2. Remove capscrew (9), clamp (10), lockwasher (2), and nut (1) from control cable (8) and control box (12).
Discard lockwasher (2).
3. Disconnect control cable (8) from cable (11) and remove control cable (8) from control box (12).
4. Remove two nuts (6), wisher (5), capscrews (4), washers (5), and control box (12) from mounting
bracket (7).
5. Slide cable (11) and grommet (3) out of control box (12).
1. Push cable (11) and grommet (3) into control box (12).
2. Install control box (12) on mounting bracket (7) with two washers (5), capscrews (4), washers (5),
and nuts (6). Tighten nuts (6) to 90 lb-ft (122 N~m).
3. Connect control cable (8) to cable (11).
4. Install control cable (8) on control box (12) with capscrew (9), clamp (10), lockwasher (2), and nut (1).
Tighten nut (1) to 6 lb-ft (8 N.m). Close and secure control box (12).
10-188
