TM 9-2320-280-20-2
9-4. FRONT BUMPER AND TOWING BRACKETS REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models
Materials/Parts
M997A2, M1025A2, M1035A2, M1043A2,
Ten locknuts (Appendix G, Item 66)
M1045A2, M1097A2
Manual References
Tools
TM 9-2320-280-24P
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Equipment Condition
Winch removed, if installed (para. 10-108).
N O TE
Perform steps 1 and 2 for bumpers with winch. Proceed to step 3 for
bumpers without winch.
1.
2.
3.
Remove four locknuts (5), washers (6), capscrews (8), washers (6), and two towing brackets (7) from
bumper (1). Discard locknuts (5).
Remove six locknuts (3), washers (4), capscrews (9), washers (4), and front bumper (1) from two mounting
brackets (2). Discard locknuts (3).
Remove four locknuts (5), washers (6), capscrews (8), washers (6), bumper (1), and two towing brackets (7)
from mounting brackets (2). Discard locknuts (5).
1.
2.
3.
9-4
NOTE
Perform step 1 for bumpers without winch. Proceed to step 2 for
bumpers with winch.
Install bumper (1) and two towing brackets (7) on two mounting brackets (2) with four washers (6),
capscrews (8), washers (6), and locknuts (5). Tighten locknuts (5) to 90 lb-ft (122 N m).
Install front bumper (1) on two mounting brackets (2) with six washers (4), capscrews (9), washers (4),
and locknuts (3). Tighten locknuts (3) to 90 lb-ft (122 N m).
Install two towing brackets (7) on bumper (1) with four washers (6), capscrews (8), washers (6) and
locknuts (5). Tighten locknuts (5) to 90 lb-ft (122 N m).
