10-47. THREE POINT SEATBELT MAINTENANCE
This task covers:
a. Front Seatbelt Removal
d. Rear Seatbelt Removal
b. Front Seatbelt Bracket Inspection
e. Rear Seatbelt Bracket Inspection
c. Front Seatbelt Installation
f.
Rear Seatbelt Installation
WARNING
Seatbelts are to be replaced as a set. Failure to do this may cause
injury to personnel or damage to equipment.
NOTE
Maintenance procedures for left and right seatbelts are basically
the same. This procedure covers left seatbelts.
1.
Remove capscrew (20), buckle assembly (21), and washer (22) from body (23).
2.
Remove capscrew (19), connector assembly (18), and washer (17) from bracket (16).
NOTE
Perform steps 3 and 4 for M1114 models only.
3.
Remove two screws (9), washers (9.1), saddle block (10), and clamp (11) from upper support (3) and
padding (5).
4.
Remove locknut (1), washer (2), screw (8), washer (7), D-ring (6), padding (5), and bracket (4) from
upper support (3). Discard locknut (1).
NOTE
Perform step 5 for M1113 models only.
5.
Remove capscrew (12), D-ring (13), and washer (14) from padding (15).
6.
Remove capscrew (24), washer (25), and retractor (26) from lower bracket (27).
1.
Inspect bracket (4) for breaks, bends, or cracks. Replace if broken, bent, or cracked.
2.
Inspect upper bracket (15) for breaks, bends, or cracks. Replace if broken, bent, or cracked (para. 10-46).
3.
Inspect lower bracket (27) for breaks, bends, or cracks. Replace if broken, bent, or cracked (para. 10-46).
b. Front Seatbelt Bracket Inspection
a. Front Seatbelt Removal
INITIAL SETUP:
Tools
General mechanics tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Locknut (Appendix G, Item 169)
Manual References
TM 9-2320-387-24P
Equipment Condition
Passenger seat removed (M1114 only)
(para. 10-45).
Companion seat and battery box cover
removed (companion seatbelt only) (para. 10-43).
General Safety Instructions
Seatbelts are to be replaced as a set.
Maintenance Level
Unit
TM 9-2320-387-24-2
10-78
Change 1