TM 9-2320-387-24-2
25-36.16
Change 1
25-13.2. 10,500 LB HYDRAULIC WINCH REPAIR (Cont'd)
20. Apply adhesive to threads of four socket-head screws (1). With drum assembly (3) in place, install
four socket-head screws (1) and two tie bars (6) on motor end/drum support (2) and gear box/drum
support (5). Tighten socket-head screws (1) to 18 lb-ft (24 N·m).
21. Apply hydraulic fluid to O-ring (11) and install into motor end (10) of drive shaft assembly (9).
Apply grease to internal splines in motor end (10) and external (8) splines of drive shaft assembly
(9).
22. Apply grease to drive shaft thrust washer (7) and install onto drive shaft assembly (9).
23. Install drive shaft assembly (9) through motor end/drum support (2) through drum assembly (3)
until splines (8) engage planetary gear assembly (4).
24. Apply hydraulic fluid to O-ring (15) and install onto motor (12). Apply grease onto splines (14) of
motor (12).
25. Apply adhesive to threads of two socket-head screws (13). Align scribe marks and install
motor (12) on motor end/drum support (2) with two socket-head screws (13). Tighten socket-head
screws (13) to 45 lb-ft (61 N·m).
6
1
1
5
4
3
2
