25-11. PASSENGER SIDE FOOTWELL INNER ARMOR MAINTENANCE
This task covers:
a.
Removal
b.
Installation
a.1. Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Eleven locknuts (Appendix G, Item 171)
Sealing compound (Appendix C, Item 72.1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24P
Equipment Condition
• Rifle support removed (para. 11-66).
• Engine access cover removed (para. 10-22).
• A/C front distribution duct removed (para. 11-81).
• A/C heater/evaporator assembly removed
(para. 25-21).
• Tunnel interior side insulation removed
(para. 10-33).
• Right front cowl insulation removed (para. 10-32).
• Surge tank removed (para. 3-65).
• Right front underbody armor removed (para. 11-38).
Maintenance Level
Direct support
TM 9-2320-387-24-2
25-30
Change 1
NOTE
If new passenger side footwell outer armor is being installed,
perform para. 11-38.1.
NOTE
Note location of capscrews and locknuts for installation.
1.
Disconnect de-icer wiring harness connector (6) and A/C power wiring connector (9) from de-icer
switch circuit breaker (5), and remove two screws (7) and de-icer switch circuit breaker (5) from
footwell armor (3).
2.
Remove eight capscrews (4) from body (8) and footwell armor (3).
3.
Remove eleven locknuts (1), capscrews (10), inner/outer cowl reinforcement (2), and footwell
armor (3) from body (8). Discard locknuts (1).
Refer to para. 10-56 for plusnut inspection and replacement.
1.
Install footwell armor (3) and inner/outer cowl reinforcement (2) on body (8) with eleven
capscrews (10) and locknuts (1). Tighten locknuts (1) to 37 lb-ft (50 N•m).
2.
Apply sealing compound to threads of eight capscrews (4), and install capscrews (4) on footwell
armor (3) and body (8). Tighten capscrews (4) to 37 lb-ft (50 N•m).
3.
Install de-ice switch circuit breaker (5) on footwell armor (3) with two screws (7), and connect
de-icer wiring harness connector (6) and A/C power wiring connector (9) to de-icer switch circuit
breaker (5).
b. Installation
a.1. Inspection
a. Removal
