TM 9-2320-387-24-2
25-4
Change 1
25-4. TURRET FRAME REPLACEMENT
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Automotive maintenance and repair: field
maintenance, basic (Appendix B, Item 6)
Materials/Parts
Eighteen locknuts (Appendix G, Item 156)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24P
Equipment Condition
Roof panel removed (para. 25-3).
Maintenance Level
Direct support
1.
Remove four screws (25), washers (25.1), two clamps (36), and saddle blocks (27) from upper
supports (12) and paddings (26).
2.
Remove two locknuts (38), washers (38.1), capscrews (19), washers (20), D-rings (21), paddings (26),
and brackets (28) from upper supports (12). Discard locknuts (38).
NOTE
Mark locations of washers and capscrews for installation.
3.
Remove six locknuts (43), washers (42), capscrews (39), two brackets (41), and spacers (40) from
B-pillar armor (37). Discard locknuts (43).
4.
Remove four locknuts (35), washers (30), capscrews (31), washers (30), two strikers (32), and
spacer(s) (33) from connecting blocks (29) and B-pillar (34). Discard locknuts (35). Keep
spacer(s) (33) with strikers (32).
4.1. Remove four locknuts (34.2), capscrews (33.1), and rear door safety strap brackets (34.1) from
connecting blocks (29) and B-pillar (34). Discard locknuts (34.2).
5.
Remove two nuts (15), washers (14), capscrews (18), and washers (14) from front mounting
clevises (16) and front supports (13).
6.
Remove two nuts (1) and washers (2) from C-pillar (4) and rear supports (5).
7.
Remove two studs (3), locknuts (8), washers (2), mounts (7), bushings (6), spacers (44), bushings (6),
and mounts (7) from C-pillar (4) and rear supports (5). Discard locknuts (8).
8.
Remove four isolation mounts (17) from two front supports (13).
9.
Remove two upper supports (12) and four connecting blocks (29) from B-pillar (34).
10.
Remove support ring (9) and two upper supports (12) from C-pillar (4) and front mounting
clevises (16).
11.
Remove six screws (10), washers (11), and two upper supports (12) from support ring (9).
12.
Remove two capscrews (22), nuts (24) and net bracket (23) from upper support (12).
a. Removal
