TM 9-2320-387-24-2
I~~~--
~~ ~~~
1 O-23. ENGINE LEFT SPLASH SHIELD MAINTENANCE
-1
This task covers:
a. Removal
b. Disassemblv
c. Assembly
d. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Eleven locknuts (Appendix G, Item 116)
Nut and lockwasher assembly
(Appendix G, Item 248)
Four rivets (Appendix G, Item 326)
Manual References
TM 9-2320-387-2413
Equipment
Condition
l Battery ground cables disconnected (para. 4-68).
l Hood prop rod and bracket removed (para. 10-8).
l Fuel drainvalve removed (Ml114
only) (para. 3-35).
General Safety Instructions
Hood must be supported during removal and
installation.
Maintenance
Level
Unit
1
a. Removal
1
1.
Disconnect hood harness connector (1) from connector (2).
NOTE
Perform steps 2 through 6 and step 9 for Ml114 models only.
Perform steps 2 through 9 for Ml113 models only.
2.
3.
Remove four capscrews (231, washers (241, and washers (25) from plate (27) and left splash shield (12).
Remove hex-head screws (28) and (301, washer (291, plates (27), and two spring nuts (26) from
headlight housing (3 1).
4.
5.
6.
7.
8.
9.
Remove four nuts (361, screws (351, and connector (2) from plate (27).
Remove nut and lo&washer assembly (321, screw (341, and harness and clamp (33) from left splash
shield (12). Discard nut and lockwasher assembly (32).
Remove locknut (3), washer (41, capscrew (201, washer (211, and left splash shield (12) from support
bracket (22). Discard locknut (3).
Remove locknut (6), washer (7), washer (81, capscrew (161, and washer (15) from left splash
shield (12) and airlift bracket (5). Discard locknut (6).
Remove capscrew (l7), washer (181, washer (19), and left splash shield (12) from airlift bracket (51.
Remove locknut (9), washer (101, capscrew (141, and washer (13) from master cylinder bracket (11)
and splash shield (12). Discard locknut (9) and remove splash shield (12) from vehicle.
WARNING
Hood must be supported during removal and installation. Failure
to support hood may cause injury to personnel or damage to
equipment.
1 O-38
