TM 9-2320-387-24-2
10-24.
ENGINE RIGHT SPLASH SHIELD MAINTENANCE
This task covers:
a. Removal
c. Assembly
b. Disassembly
d. Installation
I
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
MateriaWParts
Fifteen locknuts (Appendix G, Item 116)
Seven lockwashers (Appendix G, Item 206)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment
Condition
Hood raised and secured (TM 9-2320-387-10).
Maintenance
Level
Unit
I a. Removal I
1.
2.
3.
4.
5.
6.
7.
8.
Disconnect
hood harness connector (331 from connector (34).
Remove four capscrews (18), lockwashers (191, and washers (201 from plate (16) and splash shield
bracket (8). Discard lockwashers (19).
Remove two hex-head screws (111, harness (141, clamp (15), plate (161, and spring nuts (13) and (171
from headlight housing (12).
Remove four nuts (35), capscrews (36), and plate (16) from connector (34).
Remove locknut (lo), washer (91, capscrew (25), and washer (26) from splash shield (11 and support
bracket (24). Discard locknut (10).
NOTE
Perform steps 6 and 7 for Ml113 models only.
Remove locknut (71, washers (61 and (211, capscrews (27) and (281, washers (23) and (291, and
clamp (22) from splash shield (1) and airlift bracket (5). Discard locknut (7).
Remove locknut (30), washer (311, capscrew (21, and vent line clamp (321 from splash shield (1).
Discard locknut (30).
Remove screw (31, washer (41, and splash shield (1) from airlift bracket (5).
b. Disassembly
1.
Remove locknut (371, washer
(381, capscrew (411, washer (401, and bracket (391 from splash
shield (1). Discard locknut (371.
2.
Remove three locknuts (491, washers (481, capscrews (471, and support bracket (8) from splash
shield (11. Discard locknuts (49).
3.
Remove five’locknuts (45~ washers (441, capscrews (431, seal retainer (421, and seal (46) from splash
shield (1). Discard locknuts (451.
1 O-42
