TM 9-2320-387-24-2
12-60.2
Change 1
12-31.1. 10,500 LB WINCH HYDRAULIC HOSE REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Applicable Models:
M1113
Tools
General mechanics tool kit: automotive
(Appendix B, Item 1)
Materials/Parts
Seven tiedown straps
(Appendix G, Item 463)
Dexron III® (Appendix C, Item 37)
Locknut (Appendix G, Item 109)
Two O-rings (Appendix G, Item 86.1)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
• Hood raised and secured
(TM 9-2320-387-10)
• Engine left splash shield removed.
(para. 10-23)
• Battery ground cables disconnected.
(para. 4-68)
Maintenance Level
Unit
1.
Remove locknut (3), washer (2), capscrew (13), and two clamps (4) with hydraulic hose assemblies
(8) and (9) from winch and bumper assembly (12). Discard locknut (3).
2.
Remove three tiedown straps (1) from hydraulic hose assemblies (8) and (9), lead wire (10), and
controller plug harness (11). Discard tiedown straps (1).
CAUTION
Cover or plug power steering gear and hydro-boost connections
immediately after removing hoses to prevent contamination.
Remove all plugs prior to connecting hoses.
3.
Disconnect hydraulic hose (8) from elbow (6) at bottom winch outlet port on winch (5).
4.
Disconnect hydraulic hose (9) from elbow (7) at top winch inlet port on winch (5).
a. Removal
