TM 9-2320-387-24-2
12-2
Change 1
12-2. ENGINE/CREW COMPARTMENT HEATER HEAT SHIELD REPLACEMENT
This task covers:
a. Removal
b. Installation
INITIAL SETUP:
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Materials/Parts
Two lockwashers (Appendix G, Item 210)
Two lockwashers (Appendix G, Item 238.1)
Three lockwashers (Appendix G, Item 239.1)
Manual References
TM 9-2320-387-10
TM 9-2320-387-24P
Equipment Condition
Hood raised and secured (TM 9-2320-387-10).
General Safety Instructions
Do not touch hot exhaust system components with
bare hands.
Maintenance Level
Unit
.WARNING.
Do not touch hot exhaust system components with bare hands.
Severe injury may result.
1.
Remove nut (13), lockwasher (12), screw (14), and clamp (15) from intake pipe (16) and
heat shield (7). Discard lockwasher (12).
2.
Remove nut (13), lockwasher (12), screw (11), and clamp (2) from wiring harness (1) and
heat shield (7). Discard lockwasher (12).
3.
Remove three screws (9) and lockwashers (8) from heat shield (7) and heater (3). Discard
lockwashers (8).
4.
Remove two nuts (4), lockwashers (5), and screws (10) from heat shield (7) and
circuit breaker (6). Discard lockwashers (5).
5.
Remove heat shield (7) from heater (3).
1.
Install circuit breaker (6) on heat shield (7) with two screws (10), lockwashers (5), and nuts (4).
2.
Install heat shield (7) on heater (3) with three lockwashers (8) and screws (9).
3.
Install clamp (2) on wiring harness (1) and heat shield (7) with screw (11), lockwasher (12), and nut
(13).
4.
Install clamp (15) on intake pipe (16) and heat shield (7) with screw (14), lockwasher (12), and
nut (13).
b. Installation
a. Removal
