11-40. DRIVER’S FOOTWELL OUTER ARMOR MAINTENANCE
This task covers:
a.
Removal
c.
Installation
b.
Inspection
INITIAL SETUP:
Applicable Models
M1114
Tools
General mechanic’s tool kit:
automotive (Appendix B, Item 1)
Maintenance and repair shop equipment:
automotive (Appendix B, Item 2)
Materials/Parts
Four locknuts (Appendix G, Item 178)
Thirty-two locknuts (Appendix G, Item 169)
Sealing compound (Appendix C, Item 72.1)
Personnel Required
One mechanic
One assistant
Manual References
TM 9-2320-387-24P
Equipment Condition
• Headlight beam selector switch and bracket
removed (para. 4-59).
• Protective control box removed (para. 4-4).
Maintenance Level
Unit
TM 9-2320-387-24-2
11-82
Change 1
NOTE
If new driver’s footwell outer armor is installed, perform
para 11-36.1.
1.
Remove six capscrews (10) and spacer (6) from footwell armor (4) and A-beam armor (11).
2.
Remove twelve locknuts (9) and capscrews (13) from footwell armor (4) and outer cowl (2). Discard
locknuts (9).
3.
Remove fourteen locknuts (8) and capscrews (14) from footwell armor (4) and outer cowl (2). Discard
locknuts (8).
NOTE
Note location of screws and spacers for installation.
4.
Remove six locknuts (12), spacers (7), and capscrews (5) from footwell armor (4) and footwell (10.1).
Discard locknuts (12).
5.
Remove four locknuts (3), socket-head screws (1), and footwell armor (4) from outer cowl (2). Discard
locknuts (3).
Refer to para. 10-56 for plusnut inspection and replacement.
NOTE
Ensure large spacers are installed in upper holes.
1.
Install footwell armor (4) on footwell (10.1) with six capscrews (5), spacers (7), and locknuts (12).
Tighten locknuts (12) to 35 lb-ft (47 N•m).
2.
Secure footwell armor (4) to outer cowl (2) with four socket-head screws (1), locknuts (3), twelve
capscrews (13), locknuts (9), fourteen capscrews (14), and locknuts (8). Tighten locknuts (8) and (9) to
37 lb-ft (50 N•m). Tighten socket-head screws (1) to 10 lb-ft (13 N•m).
3.
Apply sealing compound to threads of six capscrews (10), and install spacer (6) and footwell armor (4)
on A-beam armor (11) with capscrews (10). Tighten capscrews (10) to 37 lb-ft (50 N•m).
c. Installation
b. Inspection
a. Removal
