11-39. RIGHT REAR UNDERBODY ARMOR MAINTENANCE (Cont’d)
TM 9-2320-387-24-2
11-80
Change 1
CAUTION
Ensure position of clamps on frame are under brake lines. Failure
to do so will result in damage to equipment.
NOTE
• Perform step 1 if brackets and clamps were removed.
• Ensure all old adhesive and paint is removed from area
to be adhesive bonded.
1.
Apply adhesive to two brackets (18) and install brackets (18) and four clamps (16) on frame
rail (11) with four locknuts (17).
2.
Apply sealing compound to threads of three capscrews (12), and install bar (13) and spacer (19) on
body with capscrews (12). Tighten capscrews (12) to 68-82 lb-in. (8-9 N•m).
3.
Apply sealing compound to threads of eighteen socket-head screws (22), and install armor plate (32)
and right rear underbody armor (23) on rocker panel (14) with socket-head screws (22). Tighten
socket-head screws (22) to 68-82 lb-in. (8-9 N•m).
4.
Install bar (3) and right rear underbody armor (23) on wheelwell (8) with three capscrews (1) and
locknuts (27). Tighten locknuts (27) to 10 lb-ft. (14 N•m).
5.
Apply sealing compound to threads of four socket-head screws (20), and install two plates (21) and
right rear underbody armor (23) on bracket (18) with socket-head screws (20). Tighten socket-head
screws (20) to 37 lb-ft (50 N•m).
6.
Apply sealing compound to threads of five capscrews (29), and install bracket (15) on right rear
underbody armor (23) with five washers (30) and capscrews (29). Tighten capscrews (29) to 21 lb-ft
(28 N•m).
7.
Apply sealing compound to threads of three capscrews (26), and install bracket (24) on right rear
underbody armor (23) with three washers (25) and capscrews (26). Tighten capscrews (26) to 21 lb-ft
(28 N•m).
8.
Install bracket (24) on wheelwell (8) with three washers (34), capscrews (33), and locknuts (31).
Tighten locknuts (31) to 10 lb-ft (14 N•m).
9.
Install tiedown (7) on wheelwell (8) with socket-head screw (6), washer (4), and capscrew (5).
Tighten socket-head screw (6) to 81-99 lb-ft (110-134 N•m) and capscrew (5) to 37 lb-ft (50 N•m).
10.
Install two washers (9), capscrews (10), and locknuts (28) on wheelwell (8) and right rear underbody
armor (23). Tighten capscrews (10) to 10 lb-ft (14 N•m).
c. Installation
